9/11/2023 0 Comments Eagle transmissionYou just have to pull it out by hand or with a small screwdriver and turn it to the required position. The flip chip is located at the interface between the cage and the mech. Again, you can find out which group your bike belongs to in the AXS app or on the SRAM website – the vast majority of full suspension mountain bikes belong to the B group. The setting depends on how much the chainstay length increases during compression, which is essentially the rearward axle path, divided into A-bikes with little chain growth and B-bikes with a lot of chain growth. To double check, you can use the app to see which controllers are connected to which components.Īfter that, you must select the correct position for the flip chip on the derailleur. To connect the two, you must first hold down the button on the derailleur until the light flashes slowly, then you press the button on the controller until its light flashes green. The SRAM Transmission derailleurs are compatible with both the new AXS Pods and the older AXS controllers. Next, you’ll want to connect the derailleur with the controller. The chain length depends on the bike’s chainstay length and the size of the chainring, and there’s a tool in the SRAM AXS app or on the SRAM website to help you determine it. You can also just turn the bike upside down.īefore you can start fitting components, you need to shorten the chain to the correct length. That way you don’t have any weight on the suspension and the chain isn’t under tension. How to prepare the chain, derailleur, and frame to fit the SRAM Eagle Transmissionįirst of all, it helps to hang the bike on a bike repair stand. In summary: A quick installation guide for the SRAM Eagle Transmission.Tightening the SRAM Eagle Transmission and thru axle.Mount the SRAM Eagle Transmission derailleur, attach the chain, and install the wheel.How to prepare the chain, derailleur, and frame to fit the SRAM Eagle Transmission.In the following, we explain everything in detail, but if you’re in a hurry, you can jump directly to the summary where we’ve listed all the steps without going into too much detail. However, there are a few things to keep in mind when installing the hangerless derailleur so that it can perform as intended. Since this allows the derailleur to be perfectly aligned with the cassette, there is almost no fine-tuning necessary, and the screws for the outer and inner stop as well as that of the B-gap have gone. The Eagle Transmission attaches directly to the UDH mounting point of the frame, making the derailleur hanger obsolete. Development started in 2018 and now SRAM have revealed their master plan with the launch of three new groupsets. Many years in the making, the SRAM Eagle Transmission groupset is finally here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |